Installing Water Dispenser Line - Samsung SRF719DLS User Manual

INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 138 ~ 862 kPa is required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
• Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper
tubing and 6 mm (¼") compression nut.
• The new hose-sets supplied with the appliance
are to be used and that old hose-sets should
not be reused.
DA68-03194H (EN)-06.indd 25
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Cold water line
Pipe clamp
Shut off valve
3. Connect the water line installation kit to the shut
off valve.
Cold water line
Pipe clamp
Shut off valve
Connecting the water supply line to the
refrigerator
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing
• ¼" copper tubing
• ¼" compression nut (1pc)
• Ferrule (2pc)
English - 25
Water line installation
kit
Use Plastic Tubing
• ¼" plastic tubing
→ Molded end (Bulb)
• ¼" compression nut (1pc)
2016. 3. 24. 3:21