Table of Contents
Advertisement
4
Chapter 2
Remove the power cable from the flash module as shown in Figure 7 and carefully
remove the flash module from the socket. Note the connector where the module is
located.
Install the 512MB Option kit into the 9455XL into the location of the original module.
Plug the power cable into the module.
Reinstall the CDROM bracket.
Replace the top cover
Proceed to paragraph "Verify Operation of the Unit".
Installing the Kit into the 941GXL Platform
Perform a proper shutdown of the terminal by ending your session and clicking the
buttons as they appear.
Unplug the power supply and remove all of the cables from the rear of the unit.
Remove the top cover from the 941GXL using the following steps:
Remove the top cover by removing the single screw applying pressure, using the palm of
your hand, in the direction of the arrow as shown in Figure 8
Figure 7
Figure 8
Remove the power
cable connector and
carefully remove the
flash module from
the IDE connector
noting the location of
the module.
Remove the single
screw and apply
pressure with the palm
of your hand in the
direction of the arrow.
Advertisement
Table of Contents
