Hard-Drive Backplane; Removing The Hard-Drive Backplane - Dell PowerEdge R430 Owner's Manual

Removing an expansion card
Installing an expansion card
Installing the expansion-card riser

Hard-drive backplane

Depending on your system configuration:
PowerEdge R430 Four 3.5 inch or 2.5 inch SAS/SATA backplane or
supports
Eight 2.5 inch SAS/SATA backplane or
Ten 2.5 inch SAS/SATA backplane

Removing the hard-drive backplane

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent damage to the drives and backplane, you must remove the hard drives
from the system before removing the backplane.
CAUTION: You must note the number of each hard drive and temporarily label them before
removal so that you can replace them in the same locations.
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove all hard drives.
Steps
1. Disconnect the SAS/SATA data, signal, and power cable(s) from the backplane.
2. Press the release tabs and lift the backplane upward and slide it toward the back of the chassis.
110
Safety instructions.
Before working inside your system.