LS 3603-I265A Special Operating Instructions
Host Commands
Table 1: Host Commands
Hex
Value
Rep.
0
30h
1
31h
2
32h
3
33h
4
34h
5
35h
6
36h
(73-13583-265)
Revision B: June 2000
used to identify value of param-
eter.
Command
Change Single
Parameter
Change a Group
of Parameters
Change All
Parameters
Reset Defaults
Upload All
Parameters
Software Identi-
fication Request
Control Scan-
ner's Green LED
4
Scanner
Response
If valid, the specified
parameter is changed
to the downloaded
value and an ACK
String is sent to the
host.
If valid, all the
parameters within the
specified group (set
code types, set scan
formatting bits, etc.)
are set and an ACK
String is sent to the
host. For more infor-
mation on groups see
Param Group section.
All the scanner's
parameters are set to
the specified values
and an ACK String is
sent to the host.
The scanner resets
defaults and sends an
ACK String to the
host.
The scanner's cur-
rent parameter con-
figuration is sent to
the host.
The scanner's soft-
ware identification
string is sent to the
host.
An ACK string is sent
to the host and the
scanner turns the
Green LED ON or
OFF as per the com-
mand.