Advice Regarding The First Wash Cycle; Technical Data; Installation - Hotpoint LTB 6B019 Operating Instructions Manual

*
Anti-condensation strip
After installing the dishwasher, open the door and stick the
adhesive transparent strip under the wooden shelf in order
to protect it from any condensation which may form.

Advice regarding the first wash cycle

After the installation, remove the stoppers from the racks and
the retaining elastic elements from the upper rack, if any.
Immediately before the first washing, completely fill the salt
dispenser with water and add only then approximately 1
(see chapter entitled Rinse aid and refined salt)
kg of salt
The water may overflow: this is normal and is not a cause
for concern. Select the water hardness value
entitled Rinse aid and refined salt).
poured into the machine, the LOW SALT indicator light*
switches off.
If the salt container is not filled, the water softener and
the heating element may be damaged as a result.

Technical data

width 59.5 cm
Dimensions height 82 cm
depth 57 cm
Capacity 13 standard place-settings
Water supply 0,05 ÷ 1MPa (0.5 ÷ 10 bar)
pressure 7,25 – 145 psi
Power supply voltage
See appliance data plate
Total absorbed power See appliance data plate
Fuse See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/EC (WEEE)
.
(see chapter
- After the salt has been
The machine has a buzzer/set of tones
dishwasher model
) to inform the user that a command has
been implemented: power on, cycle end etc.
The symbols/indicator lights/LEDs on the control panel/
display may vary in colour and may have a flashing or fixed
(depending on the dishwasher model)
light
The display* provides useful information concerning the
type of wash cycle, wash cycle phase, remaining time,
temperature etc.
*
Only available in selected models.
(depending on the
EN
.
19