Executing Mirror Recording - Fostex PD-6 Owner's Manual

V2.0 Supplementary manual
3) Use the [SEL] dial to highlight the "Format" menu item and press the [ENTER] key.
The display shows the top page of the "Format" screen.
We assume to use the default reel number (volume label) here, and skip to the format mode
selection. (If you want to change the volume label later, you can do it using the "Reel No"
menu item in the Utility mode.)
4) Use the [SEL] dial to highlight "Format Mode" and press the [ENTER] key.
The current format mode ("Normal" on the screen example below) flashes. You can now select
the desired format mode.
5) Use the [SEL] dial to highlight "Mirror" and press the [ENTER] key.
The format mode is set to "Mirror" and "[EXECUTE]" is highlighted.
6) While "[EXECUTE]" is highlighted, press the [ENTER] key.
The display shows the caution message before executing formatting.
By formatting PD-6 internal hard disk partition 2 (iP02HD) as the Mirror mode, the PD-6
internal DVD-RAM disk is designated as the mirror disk. Therefore, as this caution message
tells you, all data on the internal DVD-RAM disk and Model PD-6 internal hard disk partition
2 are erased by executing formatting.
To stop formatting, press the [EXIT] key repeatedly until the Utility mode exits.
7) If you are sure, press the [ENTER] key to execute formatting.
The display now shows the formatting progress screen. When formatting completes,
"Fmt.Completed!" is shown.
flashing
12
flashing
flashing