Connecting Speakers - Sherwood R-807 Operating Instructions Manual

R-807 NETWORk AV RECEIVER

Connecting Speakers

Carefully check the left (L) and right (R) channels and the polarities on the speakers being connected to this receiver.
Connecting Speaker Wires
1
Strip away approx. 10 mm (3/8 inch) of wire
insulation, and then tightly twist the wire ends.
2
Loosen the speaker terminal by turning it
counter-clockwise.
Sub
Sub
Woofer Woofer
Font Front Font Front
Right Right Left Left
14
3
4
Rear Panel
Surround Surround Surround Surround
Right Right Left Left
Insert the bare part of the wire.
Tighten the speaker terminal by turning it
clockwise.
Center Center Surround Back/ Surround Back
/Front Height
Front Height/
/Room2
Room2
Right
Right
Surround Back/ Surround Back
/Front Height
Front Height/
/Room2
Room2
Left
Left