Icom IC-910H Service Manual page 35

SOFTWARE ADJUSTMENT (continued)
ADJUSTMENT ADJUSTMENT CONDITION
TX POWER/ 7 • Connect an RF power meter to [UHF ANT]
connector.
METER
(for 430 M)
8
9
10
• Enter software adjustment mode (Refer
ADJUSTMENT 1
page 5-12).
ITEM (8)
• Push [8] key to enter the deviation adjust-
DEVIATION
ment.
• MIC gain
• Connect an FM deviation meter to [VHF
2
ANT] connector through an attenuator and
set as:
HPF
LPF
De-emphasis
Detector
3
• Connect an audio generator to [MIC] con-
nector and set as:
Frequency
Level
4
• Apply no audio signals to [MIC] connector.
5
: Center
: OFF
: 20 kHz
: OFF
: (P–P)/2
: 1.0 kHz
: 20 mVrms
From The N3UJJ.COM Document Library From The N3UJJ.COM Document Library
DISPLAY
CW
CW
CW
CW
FM
FM
FMN
FM
T
FM
T
5 - 17
OPERATION
Push [RIT] key to strat transmitting.
Tune the [MAIN DIAL] to 75 W (High
power). Push [RIT] key to store the
adjustment value into memory, and
to step next.
Tune the [MAIN DIAL] to 37.5 W
(Middle power). Push [RIT] key to
store the adjustment value into
memory, and to step next.
Verify the output power (Low) is 1–5
W, then push [RIT] key to step next.
Push [RIT] key to strat transmitting.
Tune the [MAIN DIAL] to ±4.5 kHz
FM deviation. Push [RIT] key to
store the adjustment value into
memory, and to step next.
Tune the [MAIN DIAL] to ±2.25 kHz
FM deviation. Push [RIT] key to
store the adjustment value into
memory, and to step next.
Tune the [MAIN DIAL] to ±0.6 kHz
CTCSS tone deviation. Push [RIT]
key to store the adjustment value
into memory, and to step next.
Tune the [MAIN DIAL] to ±0.6 kHz
europe tone deviation. Push [RIT]
key to store the adjustment value
into memory.
Then turn power OFF and ON to
return the normal operation mode.