GE JSP47 Installation Instructions Manual page 8

Installation Instructions
Electrical Connections
C
New Construction and
C6
Four-Conductor Branch
Circuit
NOTE: For installations where
grounding through the neutral
conductor is prohibited.
Follow instructions below
if your cord is 4-wire:
a. Remove the screws
on the terminal block.
Do not remove
terminal block.
b. Remove the green
ground screw.
Then remove the
ground strap and
discard it.
c. Attach the green
or bare wire below
the terminal block
with the green
ground screw
and washer that
were removed
earlier.
d. Connect the red
and black wires
to the outisde
terminals. The
white wire must be
connected to the
center terminal.
50 Amp 4-Wire
50 Amp 4 Wire
Remove
Remove
3 screws 3 screws
Remove and Discard
Ground Strap
Reuse Ground
Washer and
Ground Screw
Ground Wire
Terminal Block
Grounded
Neutral
Terminal
Black
White
Red
3 Screws
Ground Screw
and Washer
Center
Wire
(white)
Strain
Relief
Clamp
Follow instructions below if your
C7
cord is 3-wire:
The power cord center wire
must be connected to middle
terminal on block. Attach
remaining wires securely.
Do not remove ground strap.
Black Black
Remove
Remove
3 screws
3 screws
Ground
Wire
8
cont.
White
White
Red
Red
Connection Connection
Plate
Plate
50 Amp 3-Wire
50 Amp 3 Wire
3-Wire
3 wire
Cord Kit
cord kit
Strain
Relief
Strain
Clamp
Relief
Clamp