Dirt Container & Filter - Vax C91-PF1-B-T Instruction Manual

C91-PF1-B-T User Guide.qxd:VEC-11&21 User Guide
vax.co.uk
Position the dirt container over a rubbish bin and press the
dirt container release catch (Fig.6/3)
Fig.6/3
When all the dirt has fallen close the dirt container base,
and return the dirt container to the vacuum cleaner.
Cleaning the Filters
NOTE: Do not use any detergents or boiling water to
wash the filters. Vax recommends checking the
filters every time the dirt container is emptied and
cleaning as instructed below.
NOTE: All filters must be in place before using the
vacuum cleaner.
Central Pre-motor Filter
Remove the dirt container as directed above.
Remove the central filter as shown (Fig.6/4).
Fig.6/4
The filter can be separated into three separate parts.
Gently tap the central filter, filter shroud and filter sleeve
against the side of a rubbish bin to remove excess dirt
(Fig.6/5).
6
dirt container & filter
9/9/09 14:07
Fig.6/5
The central filter, filter shroud, and filter sleeve can be
rinsed in warm water (max 40°C).
completely before replacing (Fig.6/6).
Fig.6/6
Return the central filter, shroud and filter sleeve to the dirt
container. Replace the dirt container as directed, ensuring
that it locks into place rotating clockwise before the lid is
closed.
Post-motor Filter
NOTE: This is located on the back of the vacuum cleaner.
Release the post-motor cover by pressing down on the
catch at the top of the cover (Fig.6/7).
Fig.6/7
Remove the filter and case by pulling away from the casing,
then separate the filter from the case (Fig.6/8).
Page 6
Allow to air dry
24