Transportation And Storage; Maintenance Schedule; Intended Use - Ryobi RPP750S Original Instructions Manual

Leave about 15 cm from the trunk to the cut.
Rest the saw bar on the branch to be pruned and push
the saw gently forwards so that the ribbed bumper also
contacts the branch. This will aid stability, cutting and
provide cleaner cuts.
Small branches which are both thin in diameter and not
heavy can be cut with one cut using the bottom of the
saw bar.
For larger diameter and heavier branches where the
branch may break or split during the cut should be cut
first from under the branch using the top of the saw
bar. Make this cut approximately one third of the way
through the branch. Then make a second cut from
above the branch using the bottom of the saw bar to
Consider pruning large branches in manageable
sections rather than as a whole.
Never try to restart a previous cut with the chain and
bar in the earlier cut. Always start a new cut. This will

TRANSPORTATION AND STORAGE

Stop the machine, disconnect from mains and allow it to
cool before storing or transporting.
Clean all foreign material from the product. Store it in a
cool dry and well-ventilated place that is inaccessible
to children. Keep away from corrosive agents such
as garden chemicals and de-icing salts. Do not store
outdoors.
Cover the saw bar with the scabbard before storing the
unit, or during transportation.
When storing the unit for a long period of time (one
month or longer), be sure the chain is lightly lubricated
to prevent rust. The manufacturer recommends the use
of Ryobi bar and chain lubricant which is available from
your Ryobi authorised service centre.
For transportation, secure the machine against
damage to the machine.
MAINTENANCE
Use only original manufacturer's replacement parts,
accessories and attachments. Failure to do so can
your warranty.
Servicing requires extreme care and knowledge
technician. For service we suggest you return the
product to your nearest authorised service centre for
repair. When servicing, use only identical replacement
parts.
4
WARNING
WARNING
The saw chain is very sharp. To prevent personal
or removing the chain scabbard, and always wear
protective gloves when performing maintenance to the
chain.
Improper chain maintenance increases the potential of
kickback. Failure to replace or repair damaged chain can
Switch off and disconnect from the mains before
conducting any maintenance or cleaning work.
in this manual. For other repairs, contact the authorised
service agent.
Follow instructions for lubricating and chain tension
After each use, clean the body and handles of the
product with a soft dry cloth.
Check all nuts, bolts and screws at frequent intervals
for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.

MAINTENANCE SCHEDULE

The bar may be reversed to distribute wear for maximum
life. The bar should be cleaned every day of use and
checked for wear and damage.
Daily check
Power cable for damage
Bar lubrication
Chain tension
Chain sharpness
For damaged parts
For loose fasteners

INTENDED USE

The product is only intended for use outdoors. For safety
reasons the product must be adequately controlled by
using two handed operation.
The product is designed for cutting and pruning of small
limbs and branches whose diameter is less than or equal to
the bar length, which are high in the tree whilst the operator
maintains a steady footing on the ground. The product is
designed to be extended to a maximum length of 2.7 m. Do
not exceed this working length.
It is not intended to be used whilst climbing or as a
conventional chainsaw for close quarter limbing and
pruning of material at ground level.
WARNING
WARNING
Before each use
Before each use
Before each use and
frequently
Before each use, visual
check
Before each use
Before each use