Glass Gasket; Fan Maintenance - Regency I31-NG3 Owners & Installation Manual

GLASS GASKET

If the glass gasket requires replacement use
7/8" flat glass gasket (Part # 936-243) for the
Bay Front and for the Flush Front.

FAN MAINTENANCE

If your fan requires maintenance or replacement,
access to the fan is through the plate on the rear
wall of the firebox. NOTE: the unit MUST NOT
be operated without the fan access panel
securely in place.
CAUTION: Label all wires prior
to disconnection when servic-
ing controls. Wiring error can
cause improper and dangerous
operation.
To remove fan:
1) Turn the unit off and allow it to cool to room
temperature.
2) Unplug or disconnect power source to stove.
3) Remove glass front (see page 10).
4) Remove logs.
5) Remove brick panels.
6) Remove the Grate by removing the screws
on each side of the grate.
Grounding
Lug Detail
Remove the 2 screws holding the
grate in position.
Fan ground
Power cord
ground wire
Pilot
Assembly
OUT Pressure Tap
Regency I31-3 Gas Fireplace Inbuilt
White
Brown
7) Remove the Burner Tray by removing the
screws on each side of the tray. Push the
tray to the left and lift up.
Remove the 2 screws,
push Burner Tray to the left, and lift off.
8) Remove the 11 screws holding the Access
Panel in place.
9) Remove the Fan Air Duct by removing 4
screws, 2 per side.
Terminal
(Neutral)
240V AC
50 HZ
To
To
Thermocouple IN
Pilot
Gas
Piezo Ignitor
Green
Ground
Block
Blue
White
Yellow/Green
Brown
(Live)
Ground
White
Fan Thermodisc
(Normally open)
MAINTENANCE
10) Unplug the black wires from the fan motor
(from inside the stove).
11) Lift Fan Assembly off of the 2 pins, tip forward
and pull through firebox opening.
12) Disconnect green wire from power cord.
Replacing fan:
Reverse above steps. Hint for pushing fan down
onto pins - rub a bit of dish soap on the grommet
so it will slide more easily onto the pin. Check
to make sure the fan is seated properly on the
pins, this is very important- try to move the fan
back and forth, there should be no noise, if there
is check that the grommets haven't come loose.
Fan
Molex
Connector
HIGH
Red
OFF
LOW
Black
Yellow
ON
Burner
OFF
Orange
19