Care And Maintenance; Cleaning The Washing Machine; Caring For The Door And Drum Of Your Appliance; Cleaning The Pump - Indesit IWTE 51251 Instructions For Use Manual

Care and maintenance

Cutting off the water and electricity
GB
supplies
• Turn off the water tap after every wash cycle. This will
limit wear on the hydraulic system inside the washing
machine and help to prevent leaks.
• Unplug the washing machine when cleaning it and du-
ring all maintenance work.

Cleaning the washing machine

The outer parts and rubber components of the appliance
can be cleaned using a soft cloth soaked in lukewarm
soapy water. Do not use solvents or abrasives.
Caring for the door and drum of your
appliance
• Always leave the porthole door ajar in order to prevent
unpleasant odours from forming.

Cleaning the pump

The washing machine is fitted with a self-cleaning pump
which does not require any maintenance. Sometimes, small
items (such as coins or buttons) may fall into the pre-cham-
ber which protects the pump, situated in its bottom part.
!
Make sure the wash cycle has finished and unplug the
appliance.
Disassembly:
Press lightly on the large
button on the front of the
detergent dispenser and
pull it upwards (fig. 1).
Fig. 1
10

How to clean the detergent dispenser

Cleaning:
Then clean the dispenser under a tap (fig. 3) using an
old toothbrush and, once the pair of siphons inserted
in the top of compartments 1 and 2 (fig. 4) have been
pulled out, check whether the same are not clogged and
then rinse them.
Fig. 2
To access the pre-chamber:

Checking the water inlet hose

Check the inlet hose at least once a year. If there are any
cracks, it should be replaced immediately: during the wash
cycles, water pressure is very strong and a cracked hose
could easily split open.
!
Never use second-hand hoses.
Fig. 3
1. using a screwdriver,
remove the cover panel
on the lower front part of
the washing machine (see
figure);
2. unscrew the lid by rota-
ting it anti-clockwise (see
figure): a little water may
trickle out. This is perfectly
normal;
3. clean the inside thorou-
ghly;
4. screw the lid back on;
5. reposition the panel,
making sure the hooks are
securely in place before you
push it onto the appliance.
Reassembly:
Do not forget to reinsert
the pair of siphons into the
special housings and then
to replace the dispenser
into its seat, clicking it into
place (fig. 4, 2 and 1).
Fig. 4