1.
Connect the modem to your PC.
2.
To use a built-in modem, set the SW2-4 of the
MP card to ON.
3.
Mount the COT card in the system.
4.
Set up the MATWorX and establish the
communication setting (Modem Connect)
between your PC and the PBX using
Configuration Wizard.
5.
Set the following system data:
CM40 Y=10>1:×-×××××××× (station number)
CM13 Y=07>×-×××××××× (station number):0
NOTE:
The requirements on the PBX side are shown below.
Name
COT card
NWA-008862-001 Rev.2.1
ajch1001.fm
When using the built-in modem in the PBX,
RS1 port of the MP card cannot be used.
Requirements on PBX Side
qt.
1
Used for interface
between the PBX and
public network
CHAPTER 1 MATWorX
2. Hardware Connections
Remarks
Page 9