Setting Up For Double Or Triple Stacking In Link Mode - NEC MultiSync XT5000 User Manual

Setting up for Double or Triple Stacking in Link
Mode
O U
T P
U T
O U
T P
U T
I N P
U T
9
I N P
U T
9
OUTPUT
RGB
DIGITAL
OUTPUT
RGB
DIGITAL
OUTPUT
RGB
DIGITAL
NOTE: SW 1 Level and SW 2 Level of Switcher Control are not available on Link Mode.
For double or triple stacking, follow the instructions described below.
1) Stacking the Projectors
1-1. Place the projectors at the proper height for best screen to
projector relationship. Make sure that all projectors have the
same display orientation.
2) Hookup
2-1. Use the supplied DFP cable to connect the RGB DIGITAL
output (INPUT 9) of the master projector to the RGB DIGITAL
input of the slave projector (the second and third stack) until
all the projectors are connected.
Master projector
Slave projector
INPUT9 OUTPUT INPUT 0
SDI
DFP cable (supplied)
INPUT9 OUTPUT INPUT 0
SDI
DFP cable (supplied)
INPUT9 OUTPUT INPUT 0
SDI
REMOTE1
REMOTE1
bi-directional RS-
REMOTE1
232C cable
(not supplied)
2-2. Next, using a commercially available, bi-directional RS-232C
cable connect the OPTION OUT terminal of the master pro-
jector to the OPTION IN terminal of the slave projector(s) until
all the projectors are connected.
NOTE: When inputting signals other than those listed on page E-
44, use a commercially available distribution amplifier between
the projector and those signals because those signals are not com-
patible with this projector in the Digital Link mode.
2-3. Turn all the projectors on and roughly make some optical
adjustments to each projector.
E – 20
INPUT3 INPUT2 INPUT1 INPUT4
RGB R/Cr R/Cr Cr
G/Y G/Y
Y
OPTION
IN
B/Cb B/Cb Cb
OUT
H/HV H/HV
V V
INPUT3 INPUT2 INPUT1 INPUT4
RGB R/Cr R/Cr Cr
G/Y G/Y
Y
OPTION
IN
B/Cb B/Cb Cb
OUT
H/HV H/HV
V V
INPUT3 INPUT2 INPUT1 INPUT4
RGB R/Cr R/Cr Cr
G/Y G/Y Y
OPTION
IN
B/Cb B/Cb Cb
OUT
H/HV H/HV
V V