NEC NP4001/NP4000 User Manual page 23

I L
TEM ABEL
10.
SC TRIGGER
11.
S-VIDEO
12.
POWER SWITCH
13.
AC IN
14.
L/MONO, R
15.
VIDEO IN
COMPONENT IN
16.
(Y, Cb/Pb, Cr/Pr)
COMPUTER 2 IN
17.
(R/Cr, G/Y, B/Cb,
H, V)
18.
COMPUTER 1 IN
19.
AUDIO IN (1)
20.
LAN
21.
SERVICE
Note:
To use this feature, you must turn on the Screen Trigger function on OSD.
Screen controllers are supplied and supported by screen manufacturers.
Do not use this jack for anything other than intended use. Connecting the wired
remote control to the Trigger mini jack causes damage to the remote control.
D
ESCRIPTION
When connected to the screen through a
commercially available cable, the screen de-
ploys automatically on start up of the
projector. The screen retracts when the pro-
jector is powered off (see notes below)
Connect a commercially available S-video
cable from a video device
Turn on/off the projector
Connect the supplied power cable
Connect RCA audio cables (not supplied)
from the input device right and left channels.
This audio jack is shared with S-Video input.
Connect a composite video cable (not sup-
plied) from a video device to the yellow RCA
jack
Connect a component video enabled device
Connect RGBHV or Component signal from
computer or component video enabled device
Connect a VGA cable (not supplied) from a
computer
Connect the audio cable (not supplied) from
the input device
Connect a LAN cable (not supplied) from a
computer
Connect the USB cable (not supplied) from a
computer. For service personnel only.
11
1. Introduction
S :
EE PAGE
130
35
37, 47
36
—
35
34
31
31
—
91
—