Canon imaqeRunner 1019J Advanced Operation Manual page 183

Advanced Send
1
Features
Advanced Copy
Features 2
Network
3
Remote UI
4
System Monitor
5
System Manager
Settings 6
Reports and Lists
7
Troubleshooting
8
Appendix
9
Table of Contents
Index
Is your machine in the fax mode?
Q
Press [SEND], confirm that <FAX> is displayed,
A
then press [OK] to show the fax standby display.
Q Is the document loaded correctly?
A Make sure the document is correctly loaded. (See
Chapter 2, "Document Handling," in the Basic
Operation Guide.)
A Make sure the left and front covers are fully closed.
Q Is the one-touch key or coded dial code you
entered registered correctly?
A Check that the Address Book settings are
registered correctly. (See Chapter 4, "Sending
Documents," in the Basic Operation Guide.)
Q Did you dial the correct number?
A Check that you have the correct number.
Back Previous
Q Is the machine in the Sleep mode?
A The machine does not scan documents if it is in the
Sleep mode. To take the machine out of the Sleep
mode, press [ON/OFF] on the operation panel.
Q Is the recipient's machine out of paper?
A Ask the recipient to make sure paper is loaded in
the machine.
Q Are there other documents being sent from
memory?
A Allow time for the documents to finish sending.
Q Has an error occurred during transmission?
A Check the LCD for an error message. (See
Chapter 13, "Troubleshooting," in the Basic
Operation Guide.)
A Print an Activity Report and check for an error.
(See "ACTIVITY REPORT," on p. 7-6.)
TOP
Next
8-7