Traveler Distance From Tube Support - Stanley U-Install Owner's Manual

A. Secure one end of the cable to the chain with a master link
assembly. Make certain that the master link retaining
clip is positioned on top. See Fig. 8. Feed loose end of
cable through the idler assembly. Continue pulling cable
through idler assembly until loose end can be attached to
traveler carrier. See Fis. 8A.
TRAVELER DISTANCE FROM TUBE
SUPPORT:
39" to 41u - Tracked-Type Doors
50" to 52" - Trackless-Type Doors
B. Secure the cable to the traveler with the master link
assembly. Make certain that the master link retaining
clip is positioned on top.
IMPORTANT: MnrE cERrAtN THE TRAVELER ts postnoNED
THE CORRECT DISTANCE FROM THE END OF THE TUBE SUP.
P O R T , l F N O T , R E M O V E M A S T E R L | N K A N D G O B A C K T O
PAGE 7.
NOTE: Before pioceeding, please note that when adjusting
the chain and cable, there should be a slight chain sag, about
l/2 inch below the mid-point of the tube.
C. Adjust the chain/cable tension by tightening the adjust-
ment screw located at the rear of the tube support using a
7/16" socket wrench or screwdriver. (Clockwise rotation
w i l l t i g h t e n t h e c h a i n / c a b l e , c o u n t e r c l o c k w i s e w i l l
loosen). See Fig. 9. Be careful not to bend the screw when
adjusting.
D. Install the chain guard over the drive sprocket by pressing
down until its tabs snap into frame.
NOTE: The instruction tag describes how to manually dis-
connect the opener from the door. Please read it now because
further on in the instructions you will be instructed to "pull
the emergency release cord."
Page 8
FIG. 8A
FIG. 9
Adiustment Screw
08c.1