Table of Contents
Advertisement
WARNING: KEEP TRANSMITTER OUT OF
REACH OF CHILDREN.
ALL MODELS
A. Locate the bank of digital code switches on rear panel of
opener. With a pencil or pen, flip any combination of
switches to set your own personal code. See Figs. 39 and 40.
NOTE:
All odd numbered switches are factory set to the
OPEN position. All even numbered switches are set to the
CLOSED position.
IMPORTANT: Do ruor LEAvE rHE coDE swtrcHEs tN rHE
" A S P U R C H A S E D , ' P O S I T I O N O R S E T A L L S W I T C H E S I N T H E S A M E
P O S I T I O N .
B. Squeeze transmitter case as shown in Fig. 41 and remove
side panel. Side panel may be removed more easily by
twisting a nickel (5p) in coin slot on bottom of case.
C. With a pencil or pen, set the code switches in the identical
positions (pattern) that you set the code switches on the rear
panel ofthe opener. See Fig.42.
D. Replace access panel on transmitter.
NOTE: Small red light on top of transmitter indicates when
your transmitter is sending signal. If the light does not come on
when transmitter button is pressed, check for a dead battery.
E. Straighten the radio antenna and point it straight down. See
Fig.43.
THE TWO.BUTTON
"SIGNAL BLOCICM'' TRANSMITTER
A. If your door opener was supplied with a two-button, hand-
held Signal BlockrM transmitter, the buttons are marked
DOOR and SECURE. The DOOR button is used to conrrol
your door, and the SECURE button is used to lock out or
disable use of the DOOR button on the transmitter. This
feature adds an additional level of security to your opener,
preventing others from opening your door with a single-
button transmitter.
B. To activate the "SECURE FEATURE," your garage door
must be fully closed. Pressing the SECURE button once will
a c t i v a t e ( t u r n o n ) t h e s y s t e m ; p r e s s i n g i t a g a i n w i l l
deactivate (turn off) this system.
I M P O R T A N T : U s r r u c y o u n w A L L - M o u N T E D p u s H B u r r o N
wrLL DEACTTVATE
(TURN OFF) THE SECURE FEATURE tF tT tS
ACTIVATED. IT YOUR DOOR OPENER IS CONNECTED
TO THE
S r n r u l e y " F O U R - F U N C T I O N W A L L C O N S O L E , " u s t N c
THE CONTFOL BUTTON OR VACATION SWITCH ON THE CONSOLE
wrLL DEACIVATE (TURN OFF) THE SECURE FEATURE.
1 7 C . 4
FGG Radio Usage Limitations
CAUTION:
The garage door operator and all accessory
radio equipment has been designed to Federal Communica-
tions Standards for Part 15 radio devices. Operation of this
device is subject to the following conditions: (1) This device
may not cause harmful interference; (2) This device must
accept any interference that may be received, including
interference that may cause undesired operation; (3)
Changes or modifications not expressly approved by Stanley
Home Automation, Division of The Stanley Works, could
void the authority of users to operate this equipment.
Frc. 40
----> Code Switch Open (Off)
<-
Code Switch Closed (On)
Code
Switches
on Rear of
Opener
FtG. 41
f
Single-Button
Transmitter
Red Light
FtG. 43
FtG. 39
Page 17
Hide quick links:
Advertisement
Table of Contents
