Chain & Cable Assembly; Idler Tube Assembly - Stanley U-Install Owner's Manual

NOTICE
C H A I N & C A B L E A S S E M B L Y :
The chain and cable assembly may be pre-assembled and supplied on a roll as shown in Figure 1,
or it may not be assembled and supplied in a plastic bag and coil as shown in Figure 2 with an extra
master link to connect them as shown in Fiqure 3.
F I G U R E 1 F I G U R E 2
dffi
Cable
C h a i n
Master Link
F I G U R E 3
- Master Link
-1--t
Retaining Clip
C h a i n
Chair/Cable
I D L E R T U B E A S S E M B L Y :
lf the pulley was not pre-assembled
to the idler tube, use the 1-112'clevis
pin and lock clip to
assemble them as shown in Figure +.
F I G U R E 4
1 - 1 1 2 ' C l e v i s P i n
Lock Clip
023.0269