Pausing Or Stopping - Bowflex TreadClimber TC10 Assembly & Owners Manual

Pausing or Stopping a Workout
1. With a firm hold on the Handlebars, step off of the belts and onto the Side Foot Support Platforms on either side of the Treadles.
2. Push STOP to pause the workout. The belts will slow to a complete stop.
Note: If a paused workout is not restarted in 5 minutes, the machine will shut down and clear all workout values.
3. To restart your workout, push the START button. To end your workout, push STOP again. The Console will display your results.
To prevent unsupervised operation of the machine always remove the Safety Key and disconnect the power cord from the wall outlet and
machine AC input. Place the power cord in a secure location.
Console Service / Setup Mode
The Console has a Service / Setup Mode. Some options in the Service / Setup Mode can be adjusted to your preferences, but most are helpful for
service of the machine. To access the Service / Setup Mode, hold down the Increase and Decrease buttons for 2 seconds.
Order Display Option
1 Unit Units
2 brt Brightness
3 LOG Error Log *
4 Con Console Version *
5 dr Drive Version *
6 HrS Device Usage
7 diSt Device Mileage
8 HiSt Motor Current History *
9 Hd Hardware Type *
10 Curr Motor Current *
11 CoAS Coast Time *
12 LooP Loop Back *
13 CSn Console Serial Number
14 dSn Drive Serial Number *
15 dES Drive Error Statistics *
* for Service Technicians
Use the Increase and Decrease buttons to cycle through the Options. To change the value of an Option, push START and use the Increase and
Decrease buttons to select the desired value. Push START to assign the new value to the Option.
Push STOP to exit an Option and the Service / Setup Mode.
Description
Select your preferred unit of measurement; "Lb" = English Imperial, "Si" = metric
Control the contrast level of the Console; "8" = maximum intensity, "1" = minimum
Displays error codes, starting with the most recent
Displays the software version
Displays the drive version
Displays total number of hours and minutes used
Displays total mileage
Displays the average motor current for the current maintenance interval. Push the Decrease
button to view the averages of previous intervals.
Displays the hardware type
Displays the current of the motor
A test to see how long until the belts stop.
A test to see if the Console is receiving data.
Displays the serial number of the Console across all the displays
Displays the serial number of the Motor Control Board across all the displays
Displays the latest hard error statistics for the Motor Control Board. Push the Increase and
Decrease buttons to view all error statistics.
37
Assembly / Owner's Manual