Customer Service; Connecting To Electrical Mains - Dometic miniBar RH 465LD Operating Instructions Manual

8. Customer service

Before you call a service engineer, carry out the
following simple tests:
Problem
The appliance does
sufficiently
The appliance does not cool at all.
If after checking all the above points, the refrigerator is
still not working satisfactorily, contact your nearest
service engineer. State the problem, model, product-
and serial-number.
(Details of the model, product- and serial-number are
9. Putting into operation
Technical data:
Model
Type
Gross volume
Mains operation
Input
Energy consumption
Climate class
Refrigerant
* The energy consumption is measured at 12°C at 25°C environment
temperature (cellar).

9.1. Connecting to electrical mains

The appliance may only be operated from
nominal voltage mains as shown on the data
plate. The appliance mains plug may be connected to
a mains socket earthed in accordance with regulations.
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
The manufacturer declines any liability should
these safety measures not be observed.
Electrical Requirements
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.
not cool Too much food to be cooled was put in.
Door is not shut properly.
Internal air circulation is restricted.
CUC system stopped the operation.
Plug is not connected to the mains socket
properly
There is no voltage in the mains socket.
RH 465LD
MB20-60
34 litres
220 - 240V (AC)
65W
0,700 kWh/24h
N
147g H 2 O+98g NH 3
Possible cause
to be found on the data label in the top left of the
inside compartment.)
In the event of a fault developing, contact your
nearest Service Centre-see local telephone
directory.
www.dometic.com
Only for UK:
The appliance is supplied with a 3 Amp plug fitted.
In the event of having to change the fuse in the plug
supplied, a 3 Amp ASTA approved (BS 1362) fuse
must be used. Should the plug need to be replaced
for any reason, the wires in the mains lead are
coloured in accordance with the following code:
Green and Yellow: Earth
Blue:
Brown:
The wire coloured green and yellow must be
connected to the terminal marked with the letter "E"
or by the earth symbol
yellow.
The wire coloured blue must be connected to the
terminal "N" or coloured black.
The wire coloured brown must be connected to the
terminal marked "L" or coloured red.
Upon completion there must be no cut, or stray
strands of wire present and the cord clamp must be
secure over the outer sheath.
Solution
Put in less food to be be cooled.
Check if the door is shut.
Provide inside cool air circulation.
See operating instruction 5.3.
Check if the connection is
proper.
Check if there is voltage.
Neutral
Live
or coloured green and
GB
7