Operating - Chicago Pneumatic CP 0022 Safety And Operating Instructions Manual

CP 0022, CP 0032, CP 0069

Operating

Drilling
Use protective shoes, gloves, helmet, ear
♦
protectors and impact resistant eye protection
with side protection.
Stand firmly and always hold the machine with
♦
both hands.
Hold the inserted tool firmly against the work
♦
surface before starting the machine.
When taking a break
During all breaks you must place the machine in
♦
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
In the event of a longer break or when leaving the
♦
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.
Maintenance
Regular maintenance is a basic requirement for the
continued safe and efficient use of the machine.
Follow the maintenance instructions carefully.
♦ Before starting maintenance on the machine,
clean it in order to avoid exposure to hazard
substances. See "Dust and fume hazards"
Use only authorised parts. Any damage or
♦
malfunction caused by the use of unauthorised
parts is not covered by warranty or product
liability.
When cleaning mechanical parts with solvent,
♦
comply with appropriate health and safety
regulations and ensure there is satisfactory
ventilation.
For major service to the machine, contact your
♦
nearest authorised workshop.
After each service, check that the machine's
♦
vibration level is normal. If not, contact your
nearest authorised workshop.
9800 0901 90a | Original instructions
Safety and operating instructions
Every day
Before undertaking any maintenance or changing
the insertion tool on pneumatic machines, always
switch off the air supply and bleed the machine by
depressing the start and stop device then disconnect
the air hose from the machine.
Clean and inspect the machine and its functions
♦
each day before the work commences.
Conduct a general inspection for leaks and
♦
damage.
Check that the air inlet nipple is tightened and
♦
that the claw coupling is free from damage.
Check the function of the throttle handle. Make
♦
sure that it moves freely up and down.
♦ Check the function of the retainer. Make sure that
it locks the drill steel.
♦ Change damaged parts immediately.
Replace worn components in good time.
♦
Check the through bolts of the machine. Make
♦
sure that they are tightened.
If the machine is equipped with a muffler, check
♦
for damage.
Periodic maintenance
After each operating period of approximately 100
working hours or three times a year the machine
must be dismantled and all parts be cleaned and
checked. This work must be performed by authorized
staff, trained for this task.
19