Table of Contents
Advertisement
w a j L E o a
•"
plug ECG cable into
patient module
i
Figure 6:
A three-lead ECG cable may be connected to the patient module to
allow ECG and pulse sensor signals to be synchronized.
If you are using an ECG monitor in addition to the N-200, it may be possible to use a
synchronization signal from the ECG monitor to synchronize the N-200's measurements
to the patient's heartbeat. Ask your home care provider to determine if this can be done.
WARNING: This monitor acts as an early warning device. You must
ACT when the alarm sounds. The monitor cannot act for you.
The monitor cannot prevent your patient's oxygen saturation levels from falling below a
safe level or your patient's heart from stopping. It will, however, warn you of situations
that may be life-threatening. You must respond to alarms immediately.
Advertisement
Table of Contents
