Configuring Intrusion Protection; Configuring Secure Mac Addresses - HP 5920 Series Configuration Manual

To configure the NTK feature:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the NTK feature.

Configuring intrusion protection

Intrusion protection enables a device to take one of the following actions in response to illegal frames:
blockmac—Adds the source MAC addresses of illegal frames to the blocked MAC addresses list
•
and discards the frames. All subsequent frames sourced from a blocked MAC address are dropped.
A blocked MAC address is restored to normal state after being blocked for 3 minutes. The interval
is fixed and cannot be changed.
disableport—Disables the port until you bring it up manually.
•
disableport-temporarily—Disables the port for a specific period of time. The period can be
•
configured with the port-security timer disableport command.
To configure the intrusion protection feature:
Step
1. Enter system view.
2. Enter interface view.
3. Configure
protection feature.
4. Return to system view.
5. (Optional.) Set the silence
timeout period during which a
port remains disabled.
NOTE:
On a port operating in either macAddressElseUserLoginSecure mode or
macAddressElseUserLoginSecureExt mode, intrusion protection is triggered only after both MAC
authentication and 802.1X authentication fail for the same frame.

Configuring secure MAC addresses

Secure MAC addresses are configured or learned in autoLearn mode. If they are saved, they can survive
a device reboot. You can bind a secure MAC address to only one port in a VLAN.
Secure MAC addresses fall into static and sticky secure MAC addresses.
Command
system-view
interface interface-type
interface-number
port-security ntk-mode
{ ntk-withbroadcasts |
ntk-withmulticasts | ntkonly }
Command
system-view
interface interface-type
interface-number
port-security intrusion-mode
the intrusion
{ blockmac | disableport |
disableport-temporarily }
quit
port-security timer disableport
time-value
88
Remarks
N/A
N/A
By default, NTK is disabled on a
port and all frames are allowed to
be sent.
Remarks
N/A
N/A
By default, intrusion protection is
disabled.
N/A
By default, the port silence timeout
is 20 seconds.