Publickey Authentication Enabled Stelnet Server Configuration Example - HP 5920 Series Configuration Manual

Figure 47 Specifying the host name (or IP address)
Click Open to connect to the server.
c.
If the connection is successfully established, the system asks you to enter the username and
password. After entering the username (client001 in this case) and password (aabbcc in this case),
you can enter the command-line interface of the server.
Publickey authentication enabled Stelnet server configuration
example
Network requirements
As shown in
and are assigned the user role network-admin for configuration management. The switch acts as the
Stelnet server and uses publickey authentication and the RSA public key algorithm.
Figure 48 Network diagram
Stelnet client
192.168.1.56/24
Host
Figure 48, you can log in to the switch through the Stelnet client (SSH2) that runs on the host
Vlan-int2
192.168.1.40/24
Stelnet server
Switch
168