Configuring Port Security Features; Configuring Ntk; Configuring Intrusion Protection - HP FlexNetwork 10500 Series Security Configuration Manual

Configuring port security features

Configuring NTK

The NTK feature checks the destination MAC addresses in outbound frames to make sure frames
are forwarded only to authenticated devices.
The NTK feature supports the following modes:
•
ntkonly—Forwards only unicast frames with authenticated destination MAC addresses.
•
ntk-withbroadcasts—Forwards only broadcast frames and unicast frames with authenticated
destination MAC addresses.
•
ntk-withmulticasts—Forwards only broadcast frames, multicast frames, and unicast frames
with authenticated destination MAC addresses.
The NTK feature drops any unicast frame with an unknown destination MAC address. Not all port
security modes support triggering the NTK feature. For more information, see
To configure the NTK feature:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Configure the NTK feature.

Configuring intrusion protection

Intrusion protection enables a device to take one of the following actions in response to illegal
frames:
•
blockmac—Adds the source MAC addresses of illegal frames to the blocked MAC address list
and discards the frames. All subsequent frames sourced from a blocked MAC address are
dropped. A blocked MAC address is restored to normal state after being blocked for 3 minutes.
The interval is fixed and cannot be changed.
•
disableport—Disables the port until you bring it up manually.
•
disableport-temporarily—Disables the port for a period of time. The period can be configured
with the port-security timer disableport command.
To configure the intrusion protection feature:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Configure the intrusion
protection feature.
4. Return to system view.
Command
system-view
interface interface-type
interface-number
port-security ntk-mode
{ ntk-withbroadcasts |
ntk-withmulticasts | ntkonly }
Command
system-view
interface interface-type
interface-number
port-security intrusion-mode
{ blockmac | disableport |
disableport-temporarily }
quit
198
Table 14.
Remarks
N/A
N/A
By default, NTK is disabled on a
port and all frames are allowed to
be sent.
Remarks
N/A
N/A
By default, intrusion protection is
disabled.
N/A