Table of Contents
Advertisement
ENGINE
-
Primary Sheave
Tools required:
Chisel
Steel hammer
Primary
fixed sheave puller bolt (Special tool)
Primary sheave installer/remover
1
(Special tool)
Primary sheave installer/remover
2
(Special tool)
22 mm. socket
wrench
17 mm. socket wrench
2 -3-1.
Disassembly
(1) Straighten the primary sheave assembly
mounting
bolt lock
washer,
using the chisel and steel
hamm
-
er.
(Fig
.
2-7)
Fig.
2-7
(2) Install primary sheave holder
1 (special tool)
on the
edges of primary sliding
sheave and
primary
fixed
sheave so
that
the primary sliding sheave
is not
forced by the spring.
(Fig.
2 -8)
Fig.
2-8
(3) Using the 22-mm
.
socket wrench, remove the prima-
ry sheave assembly securing bolt and remove the
primary sheave
cap.
(Fig.
2-9)
Fig. 2-9
(4)
With primary
sheave installer/remover
1 being
in-
stalled, remove the primary
sliding sheave and pri
-
mary fixed sheave from the
crankshaft.
(Fig.
2
-10)
- - - - - - - -
Fig. 2-10
(5)
Remove
the
drive belt.
(Fig. 2
-
11)
Fig. 2-11
- 8
-
Advertisement
Table of Contents
