Kenmore Elite Ultraclean 665.1475 Series Use & Care Manual page 14

Use the stemware clips to hold stemware more securely.
Stemwclre clips (Pro model contclins 8 stemwclre clips)
The removable rack allows you to wash larger items such as
pots, roasters, and cookie sheets in the bottom rack.
IMPORTANT: Remove dishes prior to removing the top rack
from dishwasher.
To remove the rack
1. To gain access to the track stops, pull the upper rack
forward about halfway out of the tub.
2. Press on the edge of the ridged area on the track stop while
tipping the track stop toward the center of the dishwasher.
This action releases a small retaining tab that locks the
track stop to the track. (See Track stop - Left)
NOTE. It is helpful to use two hands. Take special note of
the orientation of the track stops
3. With the retaining tab released pull the track stop straight
toward the opposite track to remove it.
4. After removing both track stops, carefully pull the top rack
out of the tracks by rolling it toward you.
5. Replace the track stops by coming up from under the track
and slipping the track stop into the lower slot of the track
(See Track stop - Right) and rotate the track stop into place.
Then press on the edge of the ridged area while pushing the
track stop straight toward the track. This action locks the
retaining tab back into place.
6. Test the track stop by pulling it toward the opposite track to
ensure that it is locked in place.
Track stop - Left
Track stop - Right
To replace the rack
1. Gently pull the tracks forward in dishwasher until they stop. Remove track stops. (See steps 1-3 above)
2. Place the back wheels on each side of the rack into the track and roll the rack into the tracks, but do not push the rack all the
way into the tub.
3. Insert front rack wheels on each side of the rack into the track.
4. Slide the rack into the dishwasher.
5. Replace the track stops by coming up from under the track and slipping the track stop into the lower slot of the track (See
Track stop - Right) and rotate the track stop into place. Then press on the edge of the ridged area while pushing the track stop
straight toward the track. This action locks the retaining tab back into place.
6. Test the track stop by pulling it toward the opposite track to ensure that it is locked in place.
IMPORTANT: Be sure that the track stops are locked in place and cannot be easily removed. They keep the rack from coming out
of the track.
14