Location Of Controls - Panasonic PV-D4745S-K Operating Instructions Manual

Location of Controls (continued)
Rear View of DECK
AC Power Plug
• While plugged into an AC outlet,
this DECK consumes 0.9 W of
electrical power in off mode.
Component Video Output
Connector (Y, P
(DVD Only)
p. 13
Optical Digital Audio
Output Connector
(DVD Only)
p. 15
S-Video Out Connector
(DVD Only)
pp. 10, 13
The following table shows the status of the output jacks when in VCR or DVD mode.
Video Output
Audio Out 1
Audio Out 2
VCR
DVD
• PROG functions on the remote are not available when using Component Video Output and
Note
S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press PROG.
To enjoy PROGRESSIVE SCAN video
(1). Connect Component Video Output to the component video input terminals of a television.
(See p. 13.)
(2). When PROGRESSIVE OUT is set to "ON" in the DVD Main Menu (p. 55), a Progressive Scan
signal is output from the Component Video Output Connector .
Notes
• The screen may shift off-center when using progressive output. Please adjust the screen
position if this occurs. (Refer to your TV manual.)
• If the television is not progressive compatible, a progressive scan picture is not available.
Connect the Video Output or S-Video Output connector (see p. 12, 13) and
set PROGRESSIVE OUT to "OFF" in the DVD Main Menu. (See p. 55.)
10
D4745S-K(E) P1-25 (050120).p65
Bold: VCR Function
Bold Italic : VCR and DVD Functions
VHF/UHF Antenna Input Terminal
p. 12
, P )
B R
Audio Output 2
Connector (L/R)
p. 13
Component
Video Output
YES
N/A
YES YES
10
Italic : DVD Function
VHF/UHF Antenna Output Terminal
p.12
Video Output
Video Input
Connector
Connector
p. 12
p. 35
• • •
Audio Input
Connector (L/R)
p. 35
Audio Output 1
Connector (L/R)
p. 12
VHF/UHF
S-VIDEO OUT
Antenna Out
YES
N/A
YES
2005/01/20, 14:02