Chapter 2 : Preparations; Preparing A Power Supply; Using A Battery Pack - Sony XDCAM PMW-500 Operation Manual

2
Chapter
Preparing a Power
Supply
For safety, use only the Sony battery packs and
AC adaptors listed below.
• BP-GL95/GL65/L60S/L80S Lithium-ion
Battery Pack
• AC power using the AC-DN2B/DN10 AC
Adaptor
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the law
in the relative area or country.

Using a Battery Pack

When a BP-GL95/GL65/L60S/L80S Battery
Pack is used, the camcorder will operate
continuously for the time shown below.
Model name
BP-GL95
BP-GL65
BP-L60S
BP-L80S
WARNING
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
Note
The battery pack operating time depends on the
frequency of use of the battery pack, and the ambient
temperature when used.
Before use, charge the battery pack with a charger
suitable for each battery.
For details on the battery charging procedure, refer
to the battery charger operation manual.
34

Preparing a Power Supply

Preparations
Operating time
Approx. 180 minutes
Approx. 120 minutes
Approx. 110 minutes
Approx. 145 minutes
Note on using the battery pack
A warm battery pack may not be able to be fully
recharged.
To attach the battery pack
1
Press the battery pack against the back
of the camcorder, aligning the line on
the side of the battery pack with the
matching line on the camcorder.
1 BP-GL95/GL65/L60S/L80S
2 Align these lines.
2
Slide the battery pack down until its
"LOCK" arrow points at the matching
line on the camcorder.
1 "LOCK" arrow
2 Matching line on the camcorder