Cobra 2004 King Owner's Manual page 48

9. Insert dowel pins in the left side case as shown in figure 27.
Figure 8
10. Apply gasket sealer (ThreeBond 1104 gasket material or equivalent) to the
mating surfaces of both crankcase halves.
11. Apply the crankcase gasket to the left crank case half being sure to install the
gasket behind the connecting rod.
12. Assemble the two case halves together with the shim installed between the
crank throws. Be sure to remove the shim after assembly.
13. Insert the screws with the proper lengths at locations shown.
14. Torque to 9 Nm (80 in-lb) in the pattern shown in figure 28.
15. Install the piston with new wrist pin bearing and, pin and clips.
47
Figure 28