Table of Contents
Advertisement
Clutch
Cobra clutch puller assembly:
Figure 32
Tools recommended for clutch service:
• Universal clutch puller- a universal puller that pulls the clutch, main drive gear
and rotor. (Part # MCMUTL70).
• 5mm T-handle
• Clutch nut removal tool (Call local dealer for details)
• Cobra 3 Shoe Clutch Milk (Part # MCMUGF01).
CLUTCH REMOVAL:
1. Drain the engine transmission oil.
2. Remove the pipe and remove the 6 bolts that hold the kick-starter cover on.
3. Remove the clutch nut (not left hand thread) on the end of the crankshaft with
the clutch nut removal tool.
4. Attach the COBRA CLUTCH PULLER. There are three 6mm clutch puller
holes located on the ends of the center hub. (figures 32 & 33) You must use a
draw type puller to remove the clutch.
CAUTION:
Do not use a jaw type puller or use the 6mm tapped holes as jackscrews or you
are likely damage the clutch or drum.
5. If necessary apply heat to the center clutch hub.
CAUTION:
Clutch puller diagram
50
Figure 33
Advertisement
Table of Contents
