GE JTP26 Use And Care Manual page 20

How to Set Oven for Cleaning
Quick Reminder:
I
1. Press the AUTO SELF CLEAN pad.
until the desired Clean Time appears.
I
cycle, the word "OFF" will appear in the display.
Allow additional time for cooling before you try to
set the cycle.
1. Follow the directions in the Before a Clean Cycle
section.
2. After closing the door, press the
AUTO SELF AUTO SELF CLEAN pad.
CLEAN
3. Press the INCREASE or
DECREASE pad until the
desired Clean Time is displayed.
Clean Time is normally 3 hours. You
can change the Clean Time to any time
between 2 and 4 hours, depending on
the amount of soil in your oven.
To Stop a Clean Cycle
OFF
(continued)
The self-clean cycle will automatically begin after
1
"CLEAN" is displayed and the time for the clean cycle
I
is set. The words "ON" and "LOCK" will appe~ in the
display when the door automatically locks. It will not
be possible to open the oven door until the temperature
drops below the lock temperature and the LOCK light
goes off.
NOTE:
You can find out when the clean cycle will be
finished by pressing the STOP TIME pad.
The word "door" will be displayed, the word
"LOCK" will flash and oven control will signal if you
set the clean cycle and forget to close the oven door.
A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
2. When the LOCK light goes off and the oven has
cooled below the locking temperature, open the door.