Right Side Ebc - Jb988 - GE JB905 Technical Service Manual

Right Side EBC - JE988
• The right side EBC is located in the control
panel and is accessible by opening the control
panel cover.
• The right side Electronic Burner Control
(EBC) is a capacitance touch design circuit
board used to operate and control the right
and center-rear cooktop burners.
• The EBC manages and maintains the
selected burner temperature by regulating the
burner voltage.
Removal and Replacement
1. Disconnect power.
2. Remove the back cover and control panel
cover.
3. Label and disconnect the electrical connector
from the right side control panel circuit board.
4. Label and disconnect the ribbon connector
from the right side control panel circuit board.
5. Remove the 4 screws and right side control
panel circuit board from the control panel.
Caution: Use care when reinstalling the right
side control panel circuit board to the control
panel. Make sure to precisely align the connector
pin holes on the reverse side of the circuit board
to the connector pins on the control panel. The
pins are fragile and can be bent or broken easily.
Connector Pins
Note: When installing the ribbon connector, make
sure the red stripe on the ribbon cable is facing
up. It is important to install the ribbon connector in
the same orientation in which it was removed.
– 23 –