Stacked Iso Units Provision - Metra Electronics 99-7423 Installation Instructions Manual

STACKED ISO UNITS PROVISION

*
Note: Refer also to the instructions included with the aftermarket radio.
1 Cut and remove the center bar from
the radio housing assembly. (Figure A)
2 Snap the Double DIN brackets to the
inside edge of the radio housing
assembly. (Figure B)
3 Slide the stacked ISO units into the
bracket/radio housing assembly and
secure the units to the kit using the
screws supplied with the units.
(Figure C)
4 Snap the Double DIN trim plate onto
the front of the radio/housing assem-
bly. (Figure C)
Continue to final assembly.
99-7423 KIT ASSEMBL Y
6
A
B
C