Sagem EFT930S Installation Manual page 30

Safety instructions reminder:
Select a power supply socket in compliance with the general safety instructions given in section 1 of this document.
A = possible telephone handset
C = connection to the telephone network
= mains power supply socket
E
G = telephone network link
I = serial port (cash register, local loading tool,
etc.)
Carry out the following operations:
• Connect the terminal to the telephone network:
- Connect the telephone plug C , possibly linked with a standard connector in use in the country, to the
telephone network D . Connect the other end of the cord to socket G on the terminal.
- Connect telephone A , if any (the telephone A does not have to be present for the terminal to operate)
• Connect, if any, the serial link cord COM1 to the Connector I
• Connect, if any, the serial link cord COM2 to the Connector J
• Connect the power adapter F to the terminal ( H )
Socket G: TPSV-3 circuit: Telecommunication Power Supply Voltage, according to safety standard IEC 60950.
for the serial link COM2 ( J ) use only the cord n° 260496271 supplied by SAGEM Monetel
These connections are to be made with the device switched off.
G
G
F F
H
H
H H
G
G
B = telephone connector (country specific)
D = telephone network wall socket
= power adapter
F
H = power input
J = serial port COM2 (Option)
30/44
J
J
I I
3000139813-03/721