Connections Cover; Cable Installation - Sagem EFT930S Installation Manual

5. CONNECTIONS COVER

The connections cover is underneath the terminal
5.1 CABLE INSTALLATION (ALL PRODUCT EXECPT EFT930SL)
Precautions: Disconnect the terminal at the connection stub before opening it. Make sure that the cable used
matches the terminal type: modem cable (dark gray) or Ethernet cable (yellow).
3. Set the quarter-turn screws
vertical.
Note :
You can use the SAM cover as screwdriver
(see detail).
4. Tip the cover towards the front.
5. Plug in the connectors:
Ⓐ Power supply connector
Ⓑ Modem or Ethernet connector
Ⓒ Serial link connector
6. Install and snap fit the lead-through
(arrows 1) and put the cap in place
beside.
7. Close the cover, set the quarter-
turn screws horizontal, while
pressing the cover down firmly.
Ⓐ
Ⓑ
28/44
Ⓒ
Cap
3000139813-03/721