Osd Filter Setting - Sony RDR-GX350 Service Manual

QQ
3 7 63 1515 0

6-3-3. OSD Filter Setting

When the following trouble symptom occurs, correct it by setting the OSD filter as described below.
• Characters on the OSD screen flicker depending on the monitor connected.
[Entry]
1) Turn of the main power ON.
2) Press "ESC" on the service remote controller.
3) Press "DISP".
4) Press "DIG/ANA" four times.
OSD Filter Setting
OSD Filter : --
5) Press "ESC". (Returns to the original screen)
[Tips]
As the setting value becomes greater, jitter is reduced on a CRT display. However, as lines for characters appear thick, complex characters
may become difficult to read. On the contrary, as the setting value becomes smaller, jitter increases on a CRT display.
However, as lines for characters become sharper, complex characters become more legible.
Note1: A new setting becomes active as soon as it is made. As a new setting is stored in nonvolatile memory, it will be retrieved when the unit it turned
TE
L 13942296513
on the next time.
Note2: After the factory-preset values are downloaded, the setting value for the OSD Filter will be the default Value (4).
[Key operation of OSD Filter setting]
Key
"Rev x 3", "SPEED+"
Changing the setting value for the OSD
" x 3 Fwd", "SPEED–" Filter
"CLEAR" The setting value is reset to default.
To exit the OSD Filter Setting and clear
"ESC"
the screen (Appears the tuner screen.)
www
.
http://www.xiaoyu163.com
Operation
x ao u163
y
i
6-24E
http://www.xiaoyu163.com
2 9
8
Q Q
3 6 7 1 3 1 5
Satting value
"Rev x 3", "SPEED+"
0 – 4 (Default value: 4)
" x 3 Fwd", "SPEED–"
—
—
co
.
9 4 2 8
0 5 8 2 9 9 4 2 8
Remarks
: The setting value increases by1.
: The setting value decreases by1.
—
m
9 9
9 9