Bathrooms; Plumbing Manifold; Connections - Worcester GREENSTAR 24i Junior Installation, Commissioning And Servicing Instructions

If Side Clearances are Reduced (millimetres)
If total side clearance is Increase height
reduced to: clearances to (approx):
(Combined left & right (Combined top &
clearances excluding bottom clearances
appliance) excluding appliance)
350 441
300 523
250 617
200 717
150 856
100 1012
50 1202
Table 10 Reduced side clearances
If Front Clearance is Reduced (millimetres)
If front clearance Increase overall height
(to removable clearances to (approx):
door) is reduced (Combined top and
to: bottom clearances
excluding the appliance)
50 511
25 596
Table 11 Reduced front clearances

3.6.6 BATHROOMS

A boiler fitted with a mechanical timer or RF mechanical timer (receiver)
or FW100 controller may only be installed outside the shaded area.
A boiler with any other timer fitted (or blanking panel for an optional
programmer) can be installed in zone 2.
Additional RCD (Residual Current Device) protection may be required.
Refer to the latest IEE wiring regulations.
2* Without the end wall, zone 2 must extend 600mm from the bath
Radius 600mm
Fig. 16 Bathroom installations
6 720 802 047 (2013/05)
or Front clearance
(to removable
door) must be
increased to:
129
161
200
243
295
358
434
or Increase total side
clearance to:
(Combined left & right
clearances excluding
the appliance)
505
569
6720646608-124.3Wo
3.7

PLUMBING MANIFOLD

3.7.1 CONNECTIONS

Heating System 22mm compression fittings
DHW 15mm compression fittings
Gas 22mm compression fitting
Use the fittings supplied in the Hardware literature pack.
• If the boiler pipes are to be run behind the appliance ensure that the
pipes pass through the slot in the white cardboard guide. This is fitted
to the boiler frame.
Further guidance on pipe routing can be found printed
on the boiler template (supplied with the boiler).
• For further ease of fitting, an optional Vertical Pre-piping Assembly kit
is available, comprising five
pre-formed copper pipes and an earth bonding strip.
Part number: 7 716 192 570.
• To cover the pipe work under the boiler, down to the counter top, an
optional "Below boiler pipe cover" can be used.
Part number: 7 716 192 608
6 1 2
Fig. 17 Pipe dimensions
PRE-INSTALLATION
3 4 5 7
15