Example Programs - National Instruments NI USB-9219 User Manual

Example Programs

Installing the NI USB-9219 Device
Installing the NI USB-9219 Device into the NI USB-9162 Carrier
© National Instruments Corporation
The NI-DAQmx CD contains example programs that you can use to get
started programming with the NI USB-9219. Refer to the NI-DAQmx for
USB Devices Getting Started Guide that shipped with your device, and
is also accessible from Start»All Programs»National Instruments»
NI-DAQ, for more information.
Before installing the device, you must install the software you plan to use
with the device. Refer to the
and the documentation included with the software for more information.
The NI USB-9219 module and NI USB-9162 carrier are packaged
separately. Refer to Figure 4, while completing the following assembly
steps:
1. Make sure that no signals are connected to the NI USB-9219 module
and the USB cable is not connected to the device.
2. Remove the protective cover from the 15-pin D-SUB connector.
3. Align the I/O module with the carrier, as shown in Figure 4.
4. Squeeze the latches and insert the NI USB-9219 module into the
NI USB-9162 carrier.
Installing the Software
Figure 4. Module Installation
7 NI USB-9219 User Guide and Specifications
section of this guide