Adjusting The Size Of The Sewing Area - Pfaff 3371-1 series Instruction Manual

9

Adjusting the size of the sewing area

.07
Fig. 9 - 06
TE
With the machine in its basic position, select the input mode.
With the corresponding plus/minus key select parameter "023".
If required, enter the access code, see Chapter 11.04.01 Entering the access code.
With the corresponding plus/minus key enter the measured value (in 1/10 mm) for the
X-axis.
With the corresponding plus/minus key select parameter "024".
With the corresponding plus/minus key enter the measured value (in 1/10 mm) for the
Y-axis.
TE
Conclude the input by pressing the TE key. (Machine changes to the sewing mode).
1
P4 P7
P1 P2 P3 P5 P6
TE
No VAL
001 2700
A comparison between the sewing area size
entered and the actual sewing area size of
the work clamp ensures that seam
programs, which are not within the sewing
area size, cannot be sewn.
Measure the sewing area size of work
clamp 1.
P8
P
C1
C2
C3
TE
Setting up
If the actual and the entered
sewing area size do not concur
with each other, severe
damage can be caused to the
machine!
9 - 7