Table of Contents
Advertisement
6.2.2.6 GAMMA
6.2.2.7 APERTURE
6.2.2.8 WD-LEVEL
6.2.3
D/N SETUP
Siemens Building Technologies
Fire Safety & Security Products
0.45 or 1.0 can be selected
Move the cursor to the position as shown in the
figure to set GAMMA value.
Generally, the default value 0.45 is used for
CCTV monitor. For image processing purpose
1.0 can be selected.
Selection of picture sharpness. (LOW, MID,
HIGH)
Move the cursor to the position as shown in the
figure.
Use UP/ DOWN button, to choose HIGH, MID
or LOW.
Selection of the WD-threshold level. This setting
increases/decreases the overall video bright-
ness.
Move the cursor to the position as shown in the
figure.
Use UP/DOWN button to choose from 0 to 10.
Enter D/N SETUP submenu as shown in the
figure.
Using UP/DOWN key to adjust cursor to the
item which wants to modify.
Press ENTER key to enter modify status.
Using UP/DOWN key to select Mode.
After selected and then press ENTER key to
leave modify Mode.
Install the camera
CAMERA SETUP
EXPOSURE ALC
SHUTTER OFF
LENS LEVEL 5
WB MODE AUTO
GAIN 24
GAMMA 0.45
APERTURE MID
WD LEVEL 5
BACK
CAMERA SETUP
EXPOSURE ALC
SHUTTER OFF
LENS LEVEL 5
WB MODE AUTO
GAIN 24
GAMMA 0.45
APERTURE MID
WD LEVEL 5
BACK
CAMERA SETUP
EXPOSURE ALC
SHUTTER OFF
LENS LEVEL 5
WB MODE AUTO
GAIN 24
GAMMA 0.45
APERTURE MID
WD LEVEL 5
BACK
D/N SETUP
D/N MODE AUTO
D/N LEVEL MID
D/N DELAY 5
BACK
MAIN MANU
PRESET INROOM
<CAMERA SETUP>
<D/N SETUP>
<OPTION>
<OTHER SETUP>
<REMOTE>
<PRIVACY ZONE>
BLC ZONE OFF
SYNC MODE INT
EXIT CANCEL DEFAULT
21
08.2006
Advertisement
Table of Contents
