Fault Codes - Fisher & Paykel DW60CE Installation Instructions And User Manual

Fault codes

38
If the dishwasher malfunctions, it will display a fault code and beep. Check the table below to
see if you can correct the fault yourself before contacting Fisher & Paykel Customer Care.
If the dishwasher still will not work, or shows any other fault code
Press to turn the dishwasher off and wait a few minutes.
1
Press again to turn the dishwasher back on.
2
If the dishwasher still does not function and/or the problem persists, disconnect the dishwasher
from the power supply, turn the water supply off, then contact Fisher & Paykel Customer Care
with the fault code information.
Fault codes and Possible causes
descriptions
E1
The door has not been properly
closed or steam has forced it open.
The door is open
E2
The temperature sensor is faulty.
Sensor fault
E3
The drain hose is not connected
properly or has come loose.
Drain hose fault
E4
Drain hose is crimped or bent.
Drain fault
The waste water is not draining
out.
E5
Water tap not turned on.
No water
Insufficient water supply pressure.
Water inlet hose is crimped or bent,
so no or not enough water gets to
the dishwasher.
Drain hose is not connected
correctly.
E6
Flood switch activated.
Flooding
What to do
Close the door firmly.
Turn the water and power to the
dishwasher off, then call Customer
Care.
Ensure that the drain hose is connected
in accordance with the installation
instructions.
Check the drain hose and straighten
if needed.
Ensure that the drain hose is connected
in accordance with the installation
instructions.
Ensure the water is connected and
turned on.
Check household water pressure.
Check the water inlet hose and
straighten if needed.
Ensure that the drain hose is connected
in accordance with the installation
instructions.
Turn the water off and disconnect
the dishwasher from the power
supply. Call Customer Care.