Napoleon Electric Fireplace EF30 Installation And Operation Instructions Manual page 12

12
WARNING
!
PREPARATION FOR MAINTENANCE
Always disconnect the power and allow the electric fi replace
to cool before performing any cleaning, maintenance or
relocation of this electric fi replace. Turn controls to OFF
and remove plug from outlet or turn off the house circuit
breaker to electric fi replace receptacle.
Turn off electric fi replace or the house circuit breaker to the
fi replace before performing any cleaning and/or mainte-
nance. Allow electric fi replace to cool completely.
Most halogen light bulbs are rated to last approximately
1800 hours. Like all light bulbs, halogen bulbs require peri-
odic replacement. When the bulbs in your unit have burned
out you will notice one or more of following:
COMMON OBSERVED PROBLEMS:
- There is no fl ame
- Flame or Ember bed is dim or dark in certain areas
- Flame is not moving or glowing
Your fi replace unit must be opened in order to replace the
light bulbs. To reduce the number of times you need to
open the unit, replace all bulbs at the same time if they are
close to the end of their rated life.
WARNING
!
Do not install replacement bulbs that exceed specifi ed
maximum watts.
The halogen light bulbs in your unit can become extremely
hot. Allow at least 10 minutes between turning off the
fi replace and removing the light bulbs to avoid accidental
burns.
CAUTION
Do not handle the lamp (bulbs) with bare fi ngers, oils from
your skin will damage the bulbs whey they heat up. Use
gloves or a clean dry cloth when handling bulbs.
W415-0675 / A / 03.28.08
MAINTENANCE
There are a total of 8 halogen
light bulbs (Type GX6.35,
rated 120Volts, 35Watts) in
your unit:
- 2 bulbs provide illumination
for the ember bed
- 2 bulbs provide illumination
for fl ame generation
- 4 extra bulbs for replace-
ment
FIGURE 14
FLAME GENERATION BULB REPLACEMENT
1. Remove the 7 screws from the bottom half of the back of
fi replace shown in Figure 15. Remove back plate.
2.1. Locate the fl ame generation cylinder drum. It is con-
structed of two removable halves. (See Figure 15) They
are two (2) matte black sheet metal pieces with holes in
them, either of which can be removed from the unit. (See
Figure 15)
2.2. Remove the screw as shown in (Figure 15) that is
used to secure the fl ame generation cylinder drum.
2.3. Squeeze half of drum cylinder until its top edge clears
the top drum track. Re-
move the bottom edge
of the cylinder drum
from the bottom drum
track (See Figure 15).
This will give
you access to the
light bulbs. NOTE: Do
not exert excessive
pressures on the drum
cylinder as this may
cause damage.
3. Remove spring
clip. Hold socket and
pull out old bulb. (See
Figure 15)
4. Hold socket and
push in new bulb (DO
NOT exceed wattage).
Replace spring clip.
5. Repeat steps 3 and
4 for the second bulb.
6. Insert bottom edge
of removed cylinder
half into bottom drum
track. Gently squeeze
drum cylinder until its
top edge fi t into top
drum rack. Reattach
the screw that was
removed in step 2.2.
7. Secure the back-
plate of the unit to the
main unit by reat-
taching the 7 screws
removed from step 1.
(See Figure 15)
FIGURE 15a-d