NAPCO Gemini GEM-K2AS Operating Manual page 8

A R M I N G AW A Y : S E T T I N G T H E AL A R M W H E N L E AV I N G
T R O U B L E
A C O N
T R O U B L E
A C O N
A C O N
CAN'T/ARM/
A C O N
8
If you attempt to arm with a "TROUBLE" display (alternating with a system trouble error code), a 3-
SYSTBL/
second tone will sound at the keypad. (See SYSTEM TROUBLE ERROR CODES for descriptions of
EXX-XX codes). The window will display "CAN'T ARM". If you cannot correct the problem immediately,
pressing C
CAN'T/
Area Arming (Optional)
ARM
Some systems may be divided, or partitioned, into smaller independent subsystems, which are
referred to as Areas. In a system that has been partitioned into multiple areas, one or more area
may be armed while others remain disarmed. In a multi-area system, the area number will be
READY1
indicated by the right-most digit.
Manager's Mode The Manager's Mode, if enabled, provides quick access to other areas without
the system status display. (This is NOT a high-security feature).
To arm any area:
1. Press the numerical key representing the area number.
2. Press
3. Enter your User Code followed by
must be valid in that area.
4. Press
Global Arming
area you are in), press
AREA#
If any zone is not secured, the keypad will alternately display "CAN'T ARM / AREA #", where "#"
identifies the number of the area(s) in trouble. All problem zones in the respective area(s)
must be secured or bypassed before the area can be armed. Note: If a system trouble is
indicated, the system cannot be armed using this method.
To disarm all areas, press
will enable you to arm in this condition. Be sure to call for service as soon as possible.
U
followed by . In effect, you will now "be" in that area.
G
U
followed by to return to the home area.
G
(For GEM-P9600/3200 panels only).
, , enter your code and press
9 G
,
0 G
Q
to arm or disarm the area. Note: Your code
To arm all areas simultaneously (including the
U
.
, enter your code and press
U
.