NAPCO Gemini GEM-K2AS Operating Manual page 27

Programming Example:
Program the User 3 Code to "3784":
1. Select the Program Mode as follows:
(a)
Enter your User Code, followed by
(b)
Answer NO (press
Prog Yes/No" is displayed, then press YES (
The display will briefly read:
"User01" (User 1's Code).
2.
Press
03
3.
Press to advance to the User Code screen.
R
4.
Press
3784
If any other digits are left over from a previous User-3
Code, delete each by pressing
Note: Do not attempt to program the "OPTion" or
"ACCess" screens (if they display) as they will not be
saved.
U
5.
Press to save the code.
6.
Press to exit the Program Mode.
C
Notes:
Note: Duplicate Codes are not allowed; therefore a dupli-
P R O G R AM M I N G ( O P T I O N A L )
R
) repeatedly until "TurnOn
Q
"UPXXXX" then
for User No. 3.
to program the code.
G 0
cate Code entered in the LCD Window will erase when
pressed.
I f the system contains more than one keypad, only the
.
keypad designated "No. 1" may be used for programming
(if in doubt which is No. 1, ask your installer).
).
P
While in Program Mode, the ARMED and STATUS lights
remain off and burglar and fire alarm functions are
disabled.
In selecting your codes, do not program repetitive
numbers (1111), consecutive numbers (1234), your birth
date, address, or other obvious combinations. Choose a
code of up to six digits (a minimum of four is
recommended, and required in UL installations). If the
.
keypad detects no Program Mode activity for more than 4
minutes, a tone will sound. Press
U
is
to silence.
C
27