Image Quality - Panasonic WV-SFV310A Operating Instructions Manual

When "Constant bit rate", "Frame rate", "Advanced VBR", or "Best effort" is selected for "Transmission
priority"
•
160x120 and 160x90: 64kbps - 2048kbps*
•
QVGA, 400x300, VGA, 320x180, and 640x360: 64kbps - 4096kbps*
•
800x600: 128kbps* - 4096kbps*
•
1280x960 and 1280x720: 256kbps* - 8192kbps*
•
1920x1080 and 1600x1200: 512kbps* - 14336kbps*
•
1920x1080 (60fps) and 1280x720 (60fps): 1024kbps* - 24576kbps*
•
2048x1536: 1024kbps* - 24576kbps*
When "VBR" is selected for "Transmission priority"
•
160x120 and 160x90: 64kbps - 40960kbps*
•
QVGA, 400x300, VGA, 320x180, and 640x360: 64kbps - 40960kbps*
•
800x600: 128kbps* - 40960kbps*
•
1280x960 and 1280x720: 256kbps* - 40960kbps*
•
1920x1080 and 1600x1200: 512kbps* - 40960kbps*
•
1920x1080 (60fps) and 1280x720 (60fps): 1024kbps* - 40960kbps*
•
2048x1536: 1024kbps* - 40960kbps*
Note
•
The H.264 bit rate is restricted by "Bandwidth control(bit rate)" on the [Network] tab on the "Network"
page (®page 145). For this reason, the bit rate may be lower than the value when any value with an
asterisk (*) on the right is selected.

[Image quality]

Select the image quality of H.264 images from the following.
•
When "Transmission priority" is set to "Constant bit rate" or "Best effort": Low(Motion priority)/
Normal/ Fine(Image quality priority)
•
VBR: 0 Super fine/ 1 Fine/ 2/ 3/ 4/ 5 Normal/ 6/ 7/ 8/ 9 Low
•
Default: Normal
Note
•
When "Constant bit rate", "Best effort", or "VBR" is selected for "Transmission priority", this setting is
available.
[Smart Coding mode]
Select the adjusting method of stream transmissions from the following.
A smaller amount of data can be transmitted during video with little movement.
On/Off
•
Default: Off
Note
•
Can be set only when "Transmission priority" is set to "VBR".
•
When "Smart Coding mode" is set to "On", refresh interval is fixed at 8s.
•
When switching the "Smart Coding mode" setting from "On" to "Off", the "Refresh interval" setting will
return to the "Off" settings.
•
Turning Smart Coding mode to "On" will make refresh interval variable between 1s and 8s. If only
I-frame is used for playback and display, the display interval will change.
[Refresh interval]
Select an interval (I-frame interval; 0.2 - 5 seconds) to refresh the displayed H.264 images.
If using under a network environment with frequent error occurrences, shorten the refresh interval for H.264
to diminish image distortions. However, the refresh interval may be longer than the set value.
11 Configure the settings relating to images and audio [Image/Audio]
Operating Instructions 83