Connecting The Power Terminal - Pioneer GM-D9605 Owner's Manual

Class d five-channel amplifier
Hide thumbs Also See for GM-D9605:
Table of Contents

Advertisement

Available languages

Available languages

Section
Connecting the units
03

Connecting the power terminal

WARNING
If the battery wire is not securely fixed to the term-
inal using the terminal screws, there is a risk of
overheating, malfunction and injury, including
minor burns.
! Always use the recommended battery and
ground wire, which is sold separately. Con-
nect the battery wire directly to the car bat-
tery positive (+) terminal and the ground
wire to the car body.
! Recommended wires size (AWG: American
Wire Gauge) is as follows. The battery wire,
the ground wire and the optional direct
ground wire must be same size.
! Use a wire of 8 AWG to 16 AWG wire for the
speaker/subwoofer wire.
Battery wire and ground wire size
Wire length
less than 2.2 m (7 ft
3 in.)
less than 3.6 m (11 ft
10 in.)
less than 6.4 m (20 ft
12 in.)
1
Route battery wire from engine com-
partment to the vehicle interior.
! When drilling a cable pass-hole into the ve-
hicle body and routing a battery wire thor-
ough it, take care not to short-circuit the
wire damaging it by the cut edges or burrs
of the hole.
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive (+) battery
terminal.
2
1
12
En
Wire size
8 AWG
6 AWG
4 AWG
3
1 Positive (+) terminal
2 Battery wire (sold separately)
The maximum length of the wire between
the fuse and the positive + terminal of the
battery is 30 cm (12 in.).
3 Fuse (100 A) (sold separately)
Each amplifier must be separately fused at
100 A.
2
Use wire cutters or a utility knife to
strip the end of the battery wire, ground
wire and system remote control wire to ex-
pose about 10 mm (3/8 in.) of the end of
each of the wires, and then twist the ex-
posed ends of the wires.
3
Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
6
4
1 Battery wire
2 Power terminal
3 Ground wire
4 Ground terminal
5 System remote control wire
6 System remote control terminal
7 Terminal screws
Twist
10 mm (3/8 in.)
7
2
1
3
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents