Test Speaker Connections - Jensen CD615X Installation Instuctions

CD615X

Test Speaker Connections

These tests make sure the speakers are connected right. If speakers don't play at all, both wires
may not be connected. If the wrong speaker plays (you hear front speakers when you expect rear
speakers) make sure you connected the wires right.
Balance
1
SEL/
SEL/
SEL/
SEL/
2
VOL
VOL
3
SEL/
SEL/
SEL/
SEL/
4
VOL
VOL
Once everything is operating correctly, perform final installation described on page 10.
5293_Ein.p65
1. Press SEL four times.
2. Hold the button until
VOL
the display shows BAL.L
15.
Only the left speakers should
be playing. If not, check the
wiring. Make sure you con-
nected the wires just like the
chart on page 6.
3. Press SEL four times
again.
4. Hold the button until
VOL
the display shows BAL.R
15.
Only the right speakers
should be playing. If not,
check the wiring. Make sure
you connected the wires just
like the chart on page 6.
9
Fader
5. Press SEL five times.
5
SEL/
SEL/
SEL/
6. Hold the
SEL/
SEL/
the display shows FAD.R
15.
Only the rear speakers
should be playing. If not,
check the wiring. Make sure
you connected the wires just
6
like the chart on page 6.
VOL
VOL
7. Press SEL five times
7
SEL/
SEL/
again.
SEL/
SEL/
SEL/
8. Hold the
the display shows FAD.F
15.
Only the front speakers
should be playing. If not,
VOL
8
check the wiring. Make sure
you connected the wires just
like the chart on page 6.
VOL
4/10/99, 11:19 PM
®
button until
VOL
button until
VOL
9